HR RADIANT PROCESS HEATERS

HR Radiant Heater assemblies are Incoloy® 840 sheathed tubular heaters mounted in an aluminum housing with a reflector to provide a uniform band of radiant heat to the surface. Ideal for applications where high velocity air is not practical, such as conveyorized drying, thermoforming, ink drying, drying tunnels, shrink fitting, thermography, resin curing and wafer drying.

Broad beam - for use as a surface heating medium.
Break, splash, shockproof metal sheath heating element - extruded
aluminum housing.
Absorbed easily by all colors, clear glass, plastics, transparent solids and liquids.
FAR Infrared - Long invisible radiant wave length (2.5/3 microns).
Typical work range to 500°F, practical maximum to 900°F.
For outdoor or hazardous locations specify M7 Terminal enclosure.

Design and Installation:
Normally used perpendicular to direction of work.
May be ganged together for continuous heat bank.
Reflector normally located 12" from work. Distance can be varied due to specific
application requirements.
Snap-on nickel-plated protective grill available.
Each unit has at least two sliding steel clamps for mounting that can be positioned
at any point along the length of the housing.